Table of Contents
Advertisement
GS910/XST Series 10 Gigabit Ehternet Unmanaged Switch Installation and User's Guide
Installing a
Switch Facing Up
To install the switch on a wall with the front panel facing up, install the
brackets to support the switch from the sides as shown in Figure 30.
x
Figure 30. Installing the Brackets to Support the Switch
To install the switch on a wall with the front panel facing up, perform the
following procedure:
1. Review "Reviewing Safety Precautions" on page 32.
2. Orient the brackets against the sides of the switch.
3. Have another person hold the switch with the brackets at the location
where the switch is to be installed, while use a pencil to mark the wall
at the locations of the four holes in the brackets.
4. Pre-drill the marked locations on the wall marked in Step 3.
5. Install the four plastic anchors into the wall in the holes.
54
Advertisement
Table of Contents
