Table of Contents
Advertisement
GS910/XST Series 10 Gigabit Ehternet Unmanaged Switch Installation and User's Guide
Installing the
Switch Flat on a
Table or Desktop
The GS910/10XST switch can be installed upright on the flat
surface as shown in Figure 19. You must use the STND-03 Stand
Kit to install the switch.
Figure 19. Vertical Installation Options for the GS910/10XST Switch
Note
The STND-03 Stand Kit must be purchased separately. For
installation instructions, see "The STND-03 Stand Kit Installation
Guide."
To install the switch flat on a table or desktop, perform the following
procedure:
1. Remove all the items from the packaging.
2. Store the packaging material in a safe place.
In the event a problem occurs and you need to return the unit, use as
much of the original shipping material as possible.
3. Place the switch on a flat and secure surface, leaving ample space
around the switch for ventilation.
4. Proceed to "Cabling Twisted Pair Ports" on page 42 for the cable
installation.
38
Advertisement
Table of Contents
