Lenovo ThinkSystem SR860 V3 User Manual page 96

Attention:
• Read "Installation Guidelines" on page 43
work safely.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• To make sure that there is adequate system cooling, do not operate the server for more than two minutes
without either a drive or a drive bay filler installed in each bay.
• Before you make changes to drives, drive controllers (including controllers that are integrated on the
system board assembly), drive backplanes, or drive cables, back up all important data that is stored on
drives.
• Before you remove any component of a RAID array (drive, RAID card, etc.), back up all RAID configuration
information.
Note: For a complete list of supported optional device for this server, see
Firmware and driver download: You might need to update the firmware or driver after replacing a
component.
• Go to
https://datacentersupport.lenovo.com/products/servers/thinksystem/sr860v3/7d93/downloads/driver-
to see the latest firmware and driver updates for your server.
list/
• Go to "Update the firmware" on page 435
Procedure
Step 1. If a drive filler has been installed in the drive bay, remove it.
Figure 36. Removing 7mm drive fillers
Step 2. Gently rotate the release latch away to unlock the drive handle.
Step 3. Slide the drive into the drive bay, and push it until it stops; then, rotate the handle back to the
locked position.
ThinkSystem SR860 V3 User Guide
86
and "Safety inspection checklist" on page 44
for more information on firmware updating tools.
to ensure that you
https://serverproven.lenovo.com
.