Table of Contents
Advertisement
Figure 199. Assembling the PHM with processor in shipping tray
a.
Align the triangular mark on the heat sink label with the triangular mark on the processor carrier
and processor.
b.
Install the heat sink onto the processor-carrier.
c.
Press the carrier into place until the clips at all four corners engage. Visually inspect to make
sure that there is no gap between the processor carrier and the heat sink.
Step 5.
Install the processor-heat-sink module into the processor socket.
Notes:
• Do not touch the contacts on the bottom of the processor.
• Keep the processor socket clean from any object to prevent possible damages.
ThinkSystem SR860 V3 User Guide
248
Advertisement
Chapters
Table of Contents
