Install The Drive Backplane Carrier; Assembly - Lenovo ThinkSystem SR860 V3 User Manual

2. Connect the power and signal cables to all the backplanes. See
on page 292 for more information on the internal cable routing.
3. Reinstall all the 2.5-inch hot-swap drive and drive fillers. See
116.
4. Reinstall the fan cage. See
5. Reinstall all fan modules. See
6. Reinstall the front air baffle. See
7. Reinstall the front top cover. See
8. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
Install the drive backplane carrier assembly
Follow instruction in this section to install the drive backplane carrier assembly.
About this task
Attention:
• Read "Installation Guidelines" on page 43
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top covers,
or remove the server from the rack. See
Procedure
Step 1. Install the drive backplane carrier assembly.
ThinkSystem SR860 V3 User Guide
124
"Install the fan cage" on page
"Install a fan module" on page
"Install the front air baffle" on page
"Install the front top cover" on page
"Complete the parts replacement" on page
and "Safety inspection checklist" on page 44
58.
"Remove the server from rails" on page
"2.5-inch drive backplane cable routing"
"Install a 2.5-inch hot-swap drive" on page
129.
131.
90.
278.
58.
281.
to ensure that you