Lenovo ThinkSystem SR860 V3 User Manual page 52

• Connect server to the power source
• Connect server to the data network
• Connect the server to the storage device
• Connect the server to the management network
6. Power on the server.
Power button location and power LED are specified in:
• Chapter 2 "Server components" on page 17
• "Troubleshooting by system LEDs and diagnostics display" on page 445
The server can be turned on (power LED on) in any of the following ways:
• You can press the power button.
• The server can restart automatically after a power interruption.
• The server can respond to remote power-on requests sent to the Lenovo XClarity Controller.
Note: You can access the management processor interface to configure the system without powering
on the server. Whenever the server is connected to power, the management processor interface is
available. For details about accessing the management server processor, see "Opening and Using the
XClarity Controller Web Interface" section in the XCC documentation compatible with your server at
https://sysmgt.lenovofiles.com/help/topic/lxcc_frontend/lxcc_overview.html
7. Validate the server. Make sure that the power LED, Ethernet connector LED, and network LED are lit with
green light, which means the server hardware was set up successfully.
See "Troubleshooting by system LEDs and diagnostics display" on page 445
the LED indications.
Configure the system
Complete the following procedures to configure the system. For detailed instructions, refer to
"System configuration" on page
1. Set the network connection for the Lenovo XClarity Controller to the management network.
2. Update the firmware for the server, if necessary.
3. Configure the firmware for the server.
The following information is available for RAID configuration:
•
https://lenovopress.lenovo.com/lp0578-lenovo-raid-introduction
•
https://lenovopress.lenovo.com/lp0579-lenovo-raid-management-tools-and-resources
4. Install the operating system.
5. Back up the server configuration.
6. Install the applications and programs for which the server is intended to be used.
ThinkSystem SR860 V3 User Guide
42
433.
.
for more information on
Chapter 7