Lenovo ThinkSystem SR860 V3 User Manual page 199

RAID/HBA to flash power module, backplane 2
or 5
c. Connect the power cable to the PCIe riser; then, align and install the PCIe riser until it rests
firmly on top of the kickstands.
d. Connect the PCIe riser 3 assembly cables to the system board assembly. See
cable routing" on page 428
Step 4. If a 7mm drive cage is installed in PCIe riser 3, connect the 7mm drive cables and reinstall PCIe
riser 1.
Figure 135. Installing PCIe riser 1
a. Connect the 7mm drive cables to the system board assembly. See
cable routing" on page
b. Connect all internal cables to the PCIe adapters.
c. For six slot FH risers, route all internal cables through the cable retainer as shown below.
for more information on the internal cable routing.
416.
RAID/HBA to backplane 1, 3, 4, or 6
"7mm drive backplane
.
Chapter 5 Hardware replacement procedures
"PCIe riser 3
189