Install A Power Supply Bracket (Crps) - Lenovo ThinkSystem SR860 V3 User Manual

2. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Demo video
Watch the procedure on YouTube

Install a power supply bracket (CRPS)

Follow the instructions in this section to install a power supply bracket (CRPS).
About this task
Attention:
• Read "Installation Guidelines" on page 43
work safely.
• Power off the server and peripheral devices and disconnect the power cords and all external cables. See
"Power off the server" on page
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• If the server is installed in a rack, slide the server out on its rack slide rails to gain access to the top covers,
or remove the server from the rack. See
Note: A power supply bracket is only available on models configured with CRPS power supplies.
Procedure
Step 1. Align and install the power supply bracket into the power supply bay.
Figure 183. Installing power supply bracket
Step 2. Secure the power supply bracket.
and "Safety inspection checklist" on page 44
58.
"Remove the server from rails" on page 58.
.
Chapter 5 Hardware replacement procedures
to ensure that you
227