Lenovo ThinkSystem SR860 V3 User Manual page 103

Figure 46. Connecting cable to SATA/NVMe M.2 boot adapter
1. Connect the cables to the M.2 boot adapter.
2. Tighten the captive screw with a screwdriver to secure the cable to the M.2 boot adapter.
Step 5. If applicable, connect the flash power module to an adapter with the extension cable that comes
with the flash power module. See
information on the internal cable routing.
Figure 47. Connecting cable to flash power module
After you finish
1. If you replaced the front air baffle, reinstall the following.
a. Reinstall the M.2 boot adapter. See
b. Reinstall all flash power modules. See
2. Reinstall the front top cover. See
3. Complete the parts replacement. See
Demo video
Watch the procedure on YouTube
"Flash power module cable routing" on page 417
"Install the M.2 boot adapter" on page
"Install a flash power module" on page
"Install the front top cover" on page
"Complete the parts replacement" on page
156.
134.
278.
281.
.
Chapter 5 Hardware replacement procedures
for more
93