Lenovo ThinkSystem SR860 V3 User Manual page 368

SAS/SATA cable routing to riser 3
Note: Depending on your configuration, the RAID/HBA adapter will be installed in different riser locations.
From
BP1: SAS/SATA
1
BP3: SAS/SATA
2
2 x AnyBay + 1 x SAS/SATA backplane
Use this section to understand the signal cable routing for two AnyBay backplanes and one SAS/SATA
backplane.
Notes:
• Ensure that you observe the installation rules and sequence order in
rules and order" on page 55
• For more information on the power cable routing, see
page 292.
• Depending on your configuration, the RAID/HBA adapter will be installed in different riser locations.
• Connections between connectors;
• When routing the cables, ensure that all cables are routed appropriately through the cable guides.
This configuration contains the following storage controller combinations:
• "8i + 16i RAID/HBA adapter" on page 359
• "16i + 16i RAID/HBA adapter" on page 361
ThinkSystem SR860 V3 User Guide
358
To
32i Gen 4: C0
32i Gen 4: C1
and "Drive backplane installation rules and order" on page
↔ ↔ ↔
, ,
1 1 2 2 3
SAS/SATA cable routing to riser 1
Cable
Gen 4: SlimSAS x8 to SlimSAS x8
(1000 mm)
Gen 4: SlimSAS x8 to SlimSAS x8
(1000 mm)
"PCIe riser and adapter installation
"2.5-inch drive backplane power cable routing" on
↔
, ...
3 n n
54.