Table of Contents
Advertisement
Figure 31. Installing 7mm drive cage bracket
a.
Align the 7mm drive cage bracket with the drive cage and slide it towards the connectors.
b.
Secure the 7mm drive cage bracket with a screw.
Step 5.
Install the 7mm drive cage.
Figure 32. Installing 7mm drive cage to riser
a.
Install the drive cage into the PCIe riser cage.
b.
Secure the drive cage with two screws.
Step 6.
Connect the cables to the 7mm drive cage. See
for more information on the internal cable routing.
Install 7mm drive cage to six slot FH riser
Note: A Gen 4 riser is used as an example for illustration. The replacement procedure for a Gen 5 riser is
similar.
"7mm drive backplane cable routing" on page 416
.
Chapter 5
Hardware replacement procedures
83
Advertisement
Chapters
Table of Contents
