Lenovo ThinkSystem SR860 V3 User Manual page 91

Note: For more details on the different types of risers, see
Depending on your configuration, follow the corresponding procedures below for proper installation
procedure.
• See "Install 7mm drive cage to two slot FH riser" on page 81
– 7mm/x8/x8 PCIe G4 Riser 3 FHHL
• See "Install 7mm drive cage to six slot FH riser" on page 83
– 2 x16 & 3 x8 + 7mm PCIe G4 Riser 3 FHFL
– 3 x16 & 1 x8 + 7mm PCIe G5 Riser 3 FHFL
Install 7mm drive cage to two slot FH riser
Procedure
Step 1. Install the 7mm drive backplanes.
Figure 28. Installing 7mm drive backplane
a. Slide the lower backplane into the drive cage; then, fasten the screw to secure the lower
backplane to the drive cage.
b. Align the upper backplane with the lower backplane; then, fasten the two screws to secure
the upper backplane to the lower backplane.
Step 2. If a 7mm drive cage filler is installed, remove it.
"Rear view" on page 20.
for the following risers:
for the following risers:
.
Chapter 5 Hardware replacement procedures
81