Install A Drive Backplane - Lenovo ThinkSystem SR860 Setup Manual

Figure 64. Memory module installation
Step 4. If you are installing additional memory modules, do so now.
After installing a memory module option:
1. Reinstall the system board air baffle (see
on page 110) or processor and memory expansion tray and processor and memory expansion tray air
baffle (see "Install the processor and memory expansion tray " on page
2. Install the top cover (see
3. Reconnect the power cords and any cables that you removed.
4. If the server is installed in a rack, reinstall the server into the rack.
5. Power on the server and any peripheral devices.
6. If you have installed a DCPMM, make sure the DCPMM firmware is the latest version. If not, update it to
the latest version (see
7. Configure DCPMMs and DRAM DIMMs (see
139).

Install a drive backplane

Use this procedure to install a drive backplane.
Before installing a drive backplane:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
To install a drive backplane, complete the following steps:
Watch the procedure
A video of this procedure is available at YouTube:
PLYV5R7hVcs-Ak9fT8QAx8fLbEivizjRtp
Step 1. Determine the location of the backplane to be installed accordingly to the following combinations.
For more details about drive bay numbering, see
• One drive backplane:
"Install the system board air baffle and the power interposer"
"Install the top cover" on page
https://sysmgt.lenovofiles.com/help/topic/com.lenovo.lxca.doc/update_fw.html
56).
.
128).
"Configure Persistent Memory Module (PMem)" on page
"Safety" on page iii
https://www.youtube.com/watch?v=pIb0bIyfkDY&=
"Front view" on page
112).
and "Installation
14.
.
Chapter 3 Server hardware setup
).
105