After Repair Procedure - Mazda Mazda6 Workshop Manual Supplement

AFTER REPAIR PROCEDURE

Caution
• After repairing a malfunction, perform this procedure to verify that the malfunction has been
corrected.
• When this procedure is carried out, be sure to drive the vehicle at lawful speed and pay attention
to the other vehicles.
1. Connect the SST (WDS or equivalent) to the DLC-2.
2. Turn the ignition key to ON (engine OFF).
3. Select the clear code function and clear the DTC.
4. Perform the following trouble code inspections to ensure that the DTC has been resolved:
• For P0705
i. Start the engine.
ii. Warm up the engine to normal operating temperature.
iii. Depress the brake pedal, and shift the selector lever between P to D for 5 seconds or more.
iv. Go to Step 5.
• For P0706
i. Start the engine.
ii. Warm up the engine to normal operating temperature.
iii. Depress the brake pedal, and shift the selector lever between P to D for 100 seconds or more.
iv. Go to Step 5.
• For P0711
i. Decrease ATF temperature to 20 °C {68 °F} or below.
ii. Start the engine.
iii. Drive the vehicle in D range for 10 minutes or more.
iv. Go to Step 5
• For P0712
i. Start the engine.
ii. Warm up the engine to normal operating temperature.
iii. Drive the vehicle in D range for 20 seconds or more.
iv. Go to Step 5.
• For P0713
i. Start the engine.
ii. Warm up the engine to normal operating temperature.
iii. Drive the vehicle in D range at 20 km/h {12mph} or above for 300 seconds or more.
iv. Go to Step 5.
• For P0715; P0791
i. Start the engine.
ii. Drive the vehicle under the following conditions for 2 seconds or more.
— Vehicle speed (VSS PID): 40 km/h {25 mph} or above
— Engine speed (RPM PID): 1,500 rpm or above.
— Selector lever position: D range
iii. Repeat Step ii again.
iv. Turn the IG switch to OFF.
v. Start the engine.
vi. Drive vehicle under the following conditions for 2 second or more.
— Vehicle speed (VSS PID): 40 km/h {25 mph} or above
— Engine speed (RPM PID): 1,500 rpm or above.
— Selector lever position: D range
vii. Go to Step 5.
• For P0720
i. Start the engine.
ii. Warm up the engine and ATX.
iii. Drive vehicle under the following conditions for 2 seconds or more.
— Selector lever position: D range
— Vehicle speed (VSS PID): 40 km/h {25 mph}
— Engine speed (RPM PID): 1,500 rpm or above.
iv. Go to Step 5.
K2–124
ON-BOARD DIAGNOSTIC
A6E577018901203