Neutral Switch Removal/Installation; Manual Transaxle Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

NEUTRAL SWITCH REMOVAL/INSTALLATION

1. Remove the neutral switch.
2. Apply a light coat of silicone sealant to the screw
of the neutral switch.
Sealant
Three Bond product: TB1215
3. Install the neutral switch to the transaxle case.
Tightening torque
22.5—33.3 N·m
{2.29—3.40 kgf·m, 16.6—24.6 ft·lbf}
End Of Sie

MANUAL TRANSAXLE REMOVAL/INSTALLATION

1. Remove the battery and battery tray.
2. Remove the air cleaner compornent. (See
3. Remove the air hose above the transaxle. (See
4. Remove the air pipe above the transaxle. (See
5. Remove the solenoid bracket.
6. Remove the wheels, tires and splash shields.
7. Remove the under cover.
8. Separate the steering hose.
9. Remove the steering gear and linkage, and pipe assembly installation bolts from the front crossmember, then
suspend the steering gear and linkage with a cable. (See
(RF Turbo)) REMOVAL/INSTALLATION.)
Tightening torque
• Pipe assembly: 7.8—10.8 N·m {79.6—110.0 kgf·cm, 69.1—95.5 in·lbf}
10. Remove the front auto leveling sensor. (See Section T.)
11. Drain the transaxle oil into a suitable container.
12. Remove in the order indicated in the table.
13. Install in the reverse order of removal.
14. Adjust the headlight zeroset. (See Section T.)
15. Add the specified amount of specified transaxle oil. (See
16. Warm up the engine and transaxle, inspect for oil leakage, and inspect the transaxle operation.
MANUAL TRANSAXLE
F2–36 INTAKE-AIR SYSTEM
F2–36 INTAKE-AIR SYSTEM
F2–36 INTAKE-AIR SYSTEM
N–8 STEERING GEAR AND LINKAGE (MZR-CD
J2–4 TRANSAXLE OIL
NEUTRAL
SWITCH
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REPLACEMENT.)
A6E521219010204
A6E5212W015
A6E521201029201
J2
J2–7