Control Valve Body Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

4. Coat the oil seal with transfer oil and grease as
shown in the figure.
Caution
• The oil seal is easily damaged by the
sharp edges of the drive shaft splines. Do
not let the splines contact the oil seal.
5. Install the drive shaft and joint shaft. (See Section
M.)
End Of Sie

CONTROL VALVE BODY REMOVAL/INSTALLATION

On-Vehicle Removal
Warning
• Hot transaxle and ATF can cause severe burns. Turn off the engine and wait until it ATF have
cooled before removing the control valve body.
• Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes.
Wear protective eyes whenever using compressed air.
Caution
• Clean the transaxle exterior throughly with a stream cleaner or cleaning solvents before removal.
• If any old sealant gets into the transaxle during installation of the oil pan, trouble may occur in the
transaxle case and oil pan. Clean with cleaning fluids.
1. Clean the transaxle exterior thoroughly with a steam cleaner or cleaning solvents.
2. Disconnect the negative battery cable.
3. Remove the front bumper. (See Section S.)
4. Remove the shroud panel. (See Section S.)
5. Drain the ATF into separate containers.
6. Remove the radiator. (See Section E.)
7. Remove the oil hose. (See
8. Remove the control valve body cover.
9. Disconnect the solenoid valve connectors, then
remove harness clips.
10. Remove the control valve body.
On-Vehicle Installation
1. Position the manual valve so that it protrudes from
the control valve body end by 3.0 mm.
2. Install the control valve body while holding the
manual valve in the position.
Tightening torque
6.9—8.8 N·m
{0.70—0.90 kgf·m, 5.1—6.5 ft·lbf}
3. Connect the solenoid connectors, then install
harness clips.
4. Apply a light coat of silicon sealant to the contact
surfaces of the control valve body cover and
transaxle case.
AUTOMATIC TRANSAXLE
K2–108 OIL COOLER REMOVAL/INSTALLATION.)
OIL OIL
0.5—1.5 mm {0.0197—0.0591 in}
CONTROL
VALVE BODY
COVER
MANUAL VALVE
3.0 mm
A6E5714W130
A6E571421100202
K2
A6E5714W143
CONTROL
VALVE BODY
A6E5714W144
K2–105