Oil Cooler Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

OIL COOLER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Drain the ATF into a container. (See
3. Remove the radiator. (See Section E.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add ATF to the specified level. (See
7. Connect the negative battery cable.
8. Inspect for oil leakage from the oil pipes and oil hoses.
9. Inspect for coolant from the hoses.
10. Inspect the ATF level and condition. (See
11. Carry out the line pressure test. (See
12. Carry out the road test. (See
7.8—10.8 N·m
{80—110 kgf·cm, 69.5—95.4 in·lbf}
R
.
1 Oil hose
(See K2–109 Oil Pipe, Hose Clamp, Oil Hose
Installation Note)
2 Hose clamp
(See K2–109 Oil Pipe, Hose Clamp, Oil Hose
Installation Note)
3 Oil cooler
Radiator (In Tank Oil Cooler) Installation Note
1. The automatic transaxle oil cooler flushing must be performed whenever a transaxle is removed for service
because the existing fluid may be contaminated, and to prevent contamination of new fluid.
Note
• The flushing must be performed after installation of the overhauled or replacing transaxle.
2. Follow the instructions in the manufacturer's publication for flushing operation.
K2–108
AUTOMATIC TRANSAXLE
K2–80 AUTOMATIC TRANSAXLE FLUID (ATF)
K2–80 AUTOMATIC TRANSAXLE FLUID (ATF)
K2–78 AUTOMATIC TRANSAXLE FLUID (ATF)
K2–72 MECHANICAL SYSTEM
K2–75 ROAD TEST.)
R
R
R
TEST.)
24—35
{2.5—3.5, 18—26}
R
A B
R
7.8—10.8 N·m
{80—110 kgf·cm, 69.5—95.4 in·lbf}
4 Oil pipe
(See K2–109 Oil Pipe, Hose Clamp, Oil Hose
Installation Note)
5 Radiator (in tank oil cooler)
(See K2–108 Radiator (In Tank Oil Cooler)
Installation Note)
A6E571419900203
REPLACEMENT.)
REPLACEMENT.)
INSPECTION.)
A
B
N·m {kgf·m, ft·lbf}
A6E5714W146