Mazda Mazda6 Workshop Manual Supplement page 592

STEP
11 INSPECT TCM CIRCUIT FOR SHORT TO
GROUND
• Turn ignition key to OFF.
• Check continuity between TCM terminal 2U
(harness-side) and body ground.
• Is there any continuity?
12 VERIFY TROUBLESHOOTING OF DTC P0798
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear DTC from memory using WDS or
equivalent.
• Drive vehicle in D range and make sure that
gears shift smoothly from 1GR to 5GR.
• Is same DTC present?
13 VERIFY AFTER REPAIR PROCEDURE
• Perform "After Repair Procedure".
(See K2–124 AFTER REPAIR
• Is there any DTC present?
End Of Sie
ON-BOARD DIAGNOSTIC
INSPECTION
PROCEDURE.)
Yes Repair or replace harness, then go to next step.
No Go to next step.
Yes Replace TCM, then go to next step.
(See K2–96 TCM REMOVAL/INSTALLATION.)
No Go to next step.
Yes Go to applicable DTC inspection.
No Troubleshooting completed.
ACTION
K2–177
K2