Mazda Mazda6 Workshop Manual Supplement page 628

Hide thumbs Also See for Mazda6:

Table of Contents

Locknut Assembly Note

1. Align the mark on the center yoke and shaft, and

install the center yoke.

Tightening torque

{16.1—18.0 kgf·m, 116—130 ft·lbf}

Bearing Cup and Snap Ring Assembly Note

1. Apply the grease to the bearing rollers inside the

bearing cups.

2. Set the new spider to the yoke, and assemble the

new bearing cup as the snap ring groove comes

3. Assemble the opposite bearing cup in the same.

4. Insert the bearing cup to the yoke as the snap

ring groove width of bearing cup widens most and

both grooves width are same.

• Use a snap ring that thickness is same

for both sides.

PROPELLER SHAFT

Chapters

Table of Contents