Mazda Mazda6 Workshop Manual Supplement page 792

EXTRACTOR CHAMBER REMOVAL/INSTALLATION
WGN
1. Remove the rear bumper.
2. Remove the left side trunk side trim.
3. Squeeze the clips with your fingers and remove
the extractor chamber from the vehicle side.
4. Install in the reverse order of removal.
End Of Sie
REAR SPOILER REMOVAL/INSTALLATION
WGN
1. Disconnect the negative battery cable.
2. Remove the liftgate upper trim.
3. Remove the bolts and nuts.
4. Disconnect the high-mount brake light connector.
5. Disengage the pin A from the body, then remove
the rear spoiler.
6. Install in the reverse order of removal.
End Of Sie
ROOF RAIL REMOVAL/INSTALLATION
1. Remove the headliner.
2. Remove the nuts.
3. Remove the roof rail.
4. Install in the reverse order of removal.
End Of Sie
EXTERIOR ATTACHMENT
EXTERIOR ATTACHMENT
(SeeS–23 LIFTGATE UPPER TRIM
A
CLIP A EXTRACTOR
CHAMBER
REMOVAL/INSTALLATION)
REAR SPOILER
A
A
HIGH-MOUNT BRAKE
LIGHT CONNECTOR
NUT
8.9—12.7 {90—130, 79—112}
ROOF RAIL
A6E772851920201
A
A6E77281103
A6E772851920202
PIN A
BOLT
7.8—9.8
{79—100, 68.8—86.7}
N·m {kgf·cm, in·lbf}
A6A7728W104
A6E772851720201
NUT
6.9—9.8 N·m
{70—100 kgf·cm,
60.8—86.7 in·lbf}
A6A7728W105
S–11
S