Oil Seal Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

4. Tighten the bolt A.
Tightening torque
A: 93.1—116.6 N·m
{9.50—11.88 kgf·m, 68.66—85.98 ft·lbf}
B: 85.3—116.6 N·m
{8.70—11.88 kgf·m, 62.91—85.98 ft·lbf}
Selector Cable Installation Note
1. Install the selector lever to the manual shaft lever
in such a way that the selector cable does not
bear a load.
Note
• Install the selector lever to the manual shaft
lever with the spring side of the selector
cable end facing the upward of the vehicle.
2. Confirm that the end of the manual shaft lever
sticks out of the end of the selector cable.
End Of Sie

OIL SEAL REMOVAL/INSTALLATION

Differential side
1. Drain the ATF. (See
2. Remove the drive shaft. (See Section M.)
3. Remove and discard the oil seal using a screwdriver.
4. Using the SSTs and a hammer, tap a new oil seal
in evenly until the SSTs contacts the transaxle
case.
5. Coat the lip of the oil seal with ATF.
Caution
• The oil seal is easily damaged by the
sharp edges of the drive shaft splines. Do
not let the splines contact the oil seal.
6. Install the drive shaft. (See Section M.)
7. Add ATF to the specified level. (See
AUTOMATIC TRANSAXLE FLUID (ATF)
REPLACEMENT.)
8. Carry out the mechanical system test. (See
Transfer side
1. Remove the drive shaft and joint shaft. (See Section M.)
2. Remove and discard the oil seal using a screwdriver.
3. Using the SST and a hammer, tap a new oil seal
in evenly until the SST contacts the transfer case.
K2–104
AUTOMATIC TRANSAXLE
K2–80 AUTOMATIC TRANSAXLE FLUID (ATF)
K2–80
A
SELECTOR CABLE
MANUAL SHAFT LEVER
K2–72 MECHANICAL SYSTEM
SPRING
UPWARD
REPLACEMENT.)
49 G030 797
49 L019 016
-1.1—-0.1 mm
{-0.043—-0.004 in}
TEST.)
49 B010 001
C
B
D
A6E5714W138
A6E5714W115
A6E571419240201
A6E5714W142
A6E5714W129