Transaxle Range (Tr) Switch Adjustment - Mazda Mazda6 Workshop Manual Supplement

Hide thumbs Also See for Mazda6:

Table of Contents

TRANSAXLE RANGE (TR) SWITCH ADJUSTMENT

• Water or foreign objects entering the connector can cause a poor connection or corrosion. Be

sure not to drop water or foreign objects on the connector when disconnecting it.

1. Disconnect the TR switch connector.

2. Remove the spring and disconnect the selector

• Do not reuse the clip when any of the hooks

are deformed.

3. Remove the selector cable from the cable

4. Rotate the manual shaft to the right fully, then

return 2 notches to set the N position.

5. Loosen the TR switch mounting bolts.

• Improper adjustment of the TR switch will

cause abnormal operation of the

automatic transaxle. Be sure to use the

SST to adjust the TR switch correctly.

6. Using the SST and by turning the TR switch,

adjust the positions of the manual shaft and the

TR switch neutral hole.

7. Tighten the TR switch mounting bolts.

Tightening torque

{50—70 kgf·cm, 44—61 in·lbf}

8. Remove the SST.

9. Inspect for continuity at the TR switch. (See

80 Inspection of

Continuity.)

10. Connect the TR switch connector.

11. Connect the selector cable and install a spring.

12. Inspect operation of the TR switch. (See

AUTOMATIC TRANSAXLE

K2–80 Inspection of

TO VEHICLE FRONT

MANUAL SHAFT

A6E571419440203

Table of Contents