Transfer Removal/Installation - Mazda Mazda6 Workshop Manual Supplement

End Of Sie

TRANSFER REMOVAL/INSTALLATION

1. Disconnect the negative battery cable.
2. Remove the propeller shaft. (See
3. Remove the TWC. (See
4. Remove the front tires and splash shield of right side.
5. Remove the under cover.
6. Remove the drive shaft of right side. (See Section M.)
7. Remove the joint shaft. (See Section M.)
8. Remove the exhaust manifold insulator. (See
9. Remove the exhaust manifold. (See
10. Remove in the order shown in the figure.
11. Install in the reverse order of removal.
.
1 No.1 engine mount installation bolt
(See K2–115 No.1 Engine Mount Installation Bolt
Removal Note)
(See K2–116 No.1 Engine Mount Installation Bolt
Installation Note)
2 PTO heat shield
(See K2–116 PTO Heat Shield Installation
3 Transfer
No.1 Engine Mount Installation Bolt Removal Note
1. Support the engine using the SST before
removing the No.1 engine mount.
2. Loosen the bolt A.
3. Remove the bolt B.
4. Remove the bolt C and D.
TRANSFER
L–5 PROPELLER SHAFT
F1–30 EXHAUST SYSTEM
F1–30 EXHAUST SYSTEM
F1–30 EXHAUST SYSTEM
Note)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
REMOVAL/INSTALLATION.)
8—11
{82—112 kgf·cm, 72—96 in·lbf}
2
3
A
A6E571817001204
64—89
{6.6—9.0, 48—65}
85.3—116.6
1
{8.70—11.88,
62.91—85.98}
N·m { kgf·m, ft·lbf}
A6E5718W102
49 E017 5A0
A6E5714W132
C
B
D
A6E5714W138
K2–115
K2