Mazda Mazda6 Workshop Manual Supplement page 808

FRONT FLOOR COVERING REMOVAL/INSTALLATION
WGN
1. Disconnect the negative battery cable.
2. Remove the front seats.
3. Remove the rear seat.
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side trims.
8. Remove the B-pillar lower trims.
9. Remove the lower anchor of the front seat belt installation bolts.
10. Remove the tire house trim.
11. Remove the fuel-filler lid opener bezel.
12. Remove the fasteners.
13. Remove the cap nuts.
14. Remove the clips.
15. Take the front floor covering off from the
passenger-side door opening.
16. Install in the reverse order of removal.
End Of Sie
FLOOR COVERING
FLOOR COVERING
(SeeS–29 REAR SEAT REMOVAL/INSTALLATION)
FASTENER
CAP NUT
A6E774868670201
CLIP
FLOOR MAT
A6E77481101
S
S–27