FOREWORD
• When the customer reports vehicle malfunction, check the malfunction indicator lamp (MIL) indication, AT
warning indication, and diagnostic trouble code (DTC), then diagnose the malfunction according to following
flowchart.
— If the DTC exists, diagnose the applicable DTC inspection. (See
— If the DTC does not exist, the MIL and AT warning light does not illuminate, diagnose the applicable
symptom troubleshooting. (See
*:Malfunction Indicator lamp (MIL), AT warning light
End Of Sie
AUTOMATIC TRANSAXLE ON-BOARD DIAGNOSTIC FUNCTION
DTC Reading Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect SST (WDS or equivalent) to the vehicle
DLC-2 16-pin connector located the left side of
the center console.
3. Retrieve DTCs by SST (WDS or equivalent).
End Of Sie
ON-BOARD DIAGNOSTIC
ON-BOARD DIAGNOSTIC
K2–183 AUTOMATIC TRANSAXLE SYMPTOM
K2–126 DTC
TABLE.)
TROUBLESHOOTING.)
DLC-2
A6E577018901201
K2
YMU102WBX
A6E577018901202
A6E3970W002
K2–123