Mazda Mazda6 Workshop Manual Supplement page 689

Hide thumbs Also See for Mazda6:

Table of Contents

Spacer, Bearing Inner Race Assembly Note

Pinion height adjustment

• Use the same spacer.

• Install the spacer with the chamfer on the SST side.

1. Assemble the spacer, the bearing inner race (rear

bearing), and the SST O-ring to the SST (49 8531

565) as shown in the figure.

2. Insert the set assembled in Step 1 to the

differential gear from the rear.

3. Assemble the bearing inner race (front bearing),

SST (49 8531 567), companion flange, washer,

and locknut from the front of the differential gear.

4. Tighten the locknut to the extent that the SST (49

8531 565) can be turned by hand.

5. Place the SST (49 G027 004) on top of the SST

(49 8531 565).

6. Place the SST on the surface plate and set the

dial indicator to zero.

7. Set the SST as shown in the figure.

8. Place the measuring probe of the dial indicator so

that it contacts the place where the side bearing is

installed in the carrier. Then measure the left and

right side of the lower position.

REAR DIFFERENTIAL

Chapters

Table of Contents