Set Parameters; Modify Parameters - WEIHONG NK280B Manual

• LaMeasure(L)
For details, see NcStudio Function Manual.
To run program wizard:
1. Press Program > C to open Prog Wizard interface.
2. Use shortcuts to choose wizard type as shown on the left.

3. Set parameters.

4. Press F3 to generate and save the program file.
5. Press F1 to load the program file into the system.
The wizard program file can be used for machining directly.
For LaMeasure(L) wizard, parameter settings should conform to following rules.
• Start position and end position should be within travel range.
• One repeat refers to the process of "Start position-->End position-->Start position".
Every repeat records one group of data. When generating screw error compensation file,
average value is used.
• Measuring points should be an integer.
Set Parameters
This operation includes checking, modifying and backing up parameters.

Modify Parameters

Check parameter settings for current working conditions of the system or modify parameter
settings for enabling and disabling certain functions.
Operation
38