Execute Warm-Up And Trial Run; Manually Move Machine Tool - WEIHONG NK280B Manual

Step Operation
15(Optional) D uring machining, check current program
information, adjust motion track, return to fixed
point, workpiece origin and etc.

Execute Warm-up and Trial Run

After power up, it is not recommended to start machining directly without knowing actual
working conditions. In this case, you can use Warm-up and Trial-run function to test the
machine, including working conditions like spindle rotation, etc.
Use Warm-up and Trial-run function in following situations:
• After restarting the software
• After restarting the machine
• After all axes have been returned to the machine origin
To start warm-up and trial-run:
1. Press corresponding buttons on operational panel to turn to Jog, Handwheel or Stepping
mode.
Note that Warm-up and Trial-run is not available in REF mode.
2. Press State > A > F5 to open Warm-up and Trial-run interface.
3. Set parameters.
4. Press F1 to start warm-up and trial-run.
Any stopping actions (including manual stop, ESTOP, stopping caused by switch limit, etc.)
will stop warm-up and trial-run process.

Manually Move Machine Tool

Through related parameter settings and axis direction keys, you can control the movement of
machine tool.
To manually move machine tool:
1. Set running speed and step length.
a) Press corresponding mode button on operational panel to turn to
Jog/Handwheel/Stepping mode.
b) Press State > A.
Coor-Manual interface shows.
c) To set parameters Manual High Speed, Manual Low Speed, Custom Step of XY and Custom
Step of Z, press direction key ↑/↓/←/→ > Enter.
You can also set parameters Manual High Speed and Manual Low Speed in the Machine
Param interface.
2. Move the machine tool:
a) Select feed mode.
Reference
Adjust Track View
Return to Workpiece Origin
Return to Fixed Point
Operation
24