Access Local Files; Access Usb Program Files; Access Nk280B Program Files From Computer - WEIHONG NK280B Manual

• USB file: program files stored in a USB flash disk.
• Net file: program files stored in computer or other NK280B host.
• Wizard file: program files generated by NK280B program wizard.
NK280B supports four types of file formats:
• .nc
• .plt
• .eng
• .dxf

Access Local Files

You can access program files that are stored in D:\ directory of NK280B.
To access the local files and edit the files:
1. Press Program > A to open Local interface.
2. Operate on program files.
• F1: Load the selected program file into the system for machining.
• F2: Unload the current program file from the system.
• F3: Delete the selected program file.
• F4: Edit the selected program file. You can insert block, modify code or find and replace
characters.
• F5: Rename the selected program file.
• F6: Copy the selected program file to USB flash disk.
• F7: Create a new program file.
Only program file that is formatted with ".nc" is editable.

Access USB Program Files

You can access and edit program files that are stored in USB flash disk.
To access and edit program files from USB flash disk:
1. Press Program > B to open USB interface.
2. Operate on program files.
Operations are the same with that of editing local program files. See

Access NK280B Program Files from Computer

You can access and manage program files in control system hosts from the computer.
Two ways to access network files:
• Sharedoc
• FTP
Sharedoc
1. Open Sharedocs interface.
• Windows XP operating system: Click Start > Run, enter IP address (e.g. "\
\192.168.1.188").
Access Local Files.
Operation
36