Manage Technics; Execute Arraying; Compensate Workpiece - WEIHONG NK280B Manual

1. Press Parameter > C to open Coor Backup interface.
2. Save the current workpiece offset into the system for later use.
a) Press direction key ↑/↓ to choose line No.
b) Press F1.
The system will save the offset into the selected line No. If you do not select new line No.,
the existing offset in the line will be overwritten.
3. To avoid set workpiece offset repeatedly, recover the saved offset into the current workpiece
coordinate.
a) Press direction key ↑/↓ to choose the offset you would like to recover.
b) Press F2.
A dialog containing following information pops up.
Yes: recover offset coordinate for X-axis, Y-axis and Z-axis at the same time.
No: recover offset coordinate for X-axis and Y-axis.

Manage Technics

During machining, this operation is helpful to improve machining performance. NK280B motion
control system offers several machining technics, you can set it in Technics Management
interface.

Execute Arraying

For batch machining, you can use arraying function to improve efficiency.
For details, see NcStudio Function Manual.
To enable arraying function:
1. Press Advanced > = > F1.
It opens Array interface.
2. Set parameters.
For details about parameters, see NcStudio Function Manual.
3. Press Start button on operational panel.
The system executes arraying automatically according to parameter settings.

Compensate Workpiece

You can compensate workpiece to correct the workpiece dimension offset due to tool wear or
other causes.
Before stetting parameters for workpiece compensation, set parameters for arraying first.
To compensate workpiece:
1. Press Advanced > = > F2.
Workpiece Compensation interface opens.
2. Set compensation parameters.
If the desired workpiece dimension is: X=120mm, Y=80mm
The the actual piecework dimension is: X=120.001mm, Y=79.999mm
Operation
31