Manually Set Ip Address; Automatically Set Ip Address; Modify Device Information - WEIHONG NK280B Manual

3. Verify connection.

Manually Set IP Address

If DHCP function is not supported, you need to manually set IP address of both NK280B and the
computer.
When the computer and NK280B is directly connected by net cable, or one computer is
connected with several NK280B via router. DHCP function is not supported.
Manually set IP address of the computer and NK280B:
1. Set IP address of the computer.
2. Turn to NK280B. Press System > C > F7 > F5.
IP Setup dialog box opens.
3. Press S, and enter address information in the dialog box.
You need to set up both the IP address and submask.
4. After setup, you can turn to Net Info interface to check the updated net information.
An example of setup of IP address and submask of both the computer and NK280B:
IP address: 192.168.1.188 (IP address of the first group of NK280B should be the same as
those of the computer).
Subnet mask: 255.255.255.0 (Subnet mask of NK280B should be the same as that of the
computer).
Default gateway: 192.168.1.1 (Gateway of NK280B should be the same as that of the
computer).

Automatically Set IP Address

If the devices support DHCP function, the system can obtain IP address automatically.
Make sure all devices support DHCP function and all devices have been well connected.
To automatically set IP address of the computer and NK280B:
1. Obtain IP address of the computer.
2. Obtain IP address of NK280B.
a) Press System > C > F7 > F5 to open IP Setting dialog box.
b) Press L to select automatic way, and press Enter.

Modify Device Information

If there are more than one NK280B, IP address and MAC address of each of them should not be
the same. If the same, manually reset IP address and MAC address.
To manually set IP address and MAC address of NK280B:
1. Press System > > F6 to open Device Info dialog box.
Operation
34