Adjust Track View - WEIHONG NK280B Manual

• Press State > C > F1.
• Press State > A > F2.
Start Line dialog box pops up.
3. Set parameters for selective machining, including "Start" position and "End" position.
Shortcut keys: T for "File header", S for block No. of start position, P for "File End" and Q
for block No. of end position.

Adjust Track View

Track gives a three-dimensional display of the tool path in real time. Users can view the tool
path more institutionally.
To adjust track of the tool path:
1. Press State > B to open Motion Trace interface.
2. Scale track on the interface.
• Zoom Out: Press F3 to enlarge the track to check some details.
• Zoom In: Press F4 to shrink the track.
3. Adjust position of track on the interface.
• Center: Press F5 to move the track to the center.
• Move: Press arrow keys (← → ↑ ↓) to move the track to the left, right, up and down.
4. Press P or Q to change observation view of track.
Press P to switch to next view and press Q to switch to previous view.
Operation
42