Loading And Unloading - PRONAR RC3100 Operator's Manual

Section 2

2.6 LOADING AND UNLOADING

• Loading and unloading work should
be carried out by persons experi-
enced in this type of work.
• The trailer is not intended for trans-
porting people, animals or hazardous
materials.
• The load must not protrude further
out than the load platform's front wall.
The load must be arranged in such
a way that it does not threaten the
stability of the trailer and does not
hinder driving.
• Load must be protected against
moving by means of belts, chains,
straps or other certified securing
measures
mechanism.
• The arrangement of the load must not
cause overloading the axle system.
• Incorrect load distribution and over-
loading the machine may cause the
trailer to tip over or cause damage to
its components.
• Do NOT climb on the load platform
during loading. Secure the load only
when the machine rests on the load
platform planks.
2.12 PRONAR RC3100
with a tensioning
• Unloading and loading of trailer may
only take place when the machine is
positioned on level and hard surface
and connected to tractor. Tractor
and trailer must be placed to drive
forwards.
• Ensure that there are no bystanders
in the unloading/loading zone.
• Be especially careful when opening
or closing the ramps because there
is a risk of crushing fingers. Unfolded
ramps must adhere to a level surface
and must be at the same height.
• Loading equipment may work on the
load platform only if the total weight
of the loading equipment and the
load does not exceed the maximum
carrying capacity of the trailer.
• Do not exceed the permissible load
weight when using the hydraulic
winch.
• When using the trailer's ramps during
loading and unloading, use the rear
load platform supports. Be especially
careful when using the supports be-
cause there is a risk of crushing
fingers. Use protective gloves.
Safety advice
F.3.1.209.06.1.EN