PRONAR RC3100 Operator's Manual page 70

Section 4
of the support (3) - figure (4.6).
Raise the support slightly up to
make it easier to remove the
safety pin.
• Holding the handle (5), unfold the
support and secure it with the pin (2).
• Unlock and remove the pin (1).
To facilitate the removal of the
pin, raise the foot until the pin
rotates easily.
• Slide out the support foot (4) to the de-
sired height and secure it by locking
with a pin (1).
• Unfold the other rear support in the
same way.
• Release the ramp's spring catch
mechanism.
Pull the lever back to position
(2) - figure (4.7). In this position,
the catch lever cannot be auto-
matically closed.
• Lower the ramps with the aid of the
tractor's hydraulic system.
Move the levers of the hydraulic
distributor (2) to position "2"-
lowering the ramps.
4.14 PRONAR RC3100
RISING THE RAMPS
• Move the spring catch to the ramp
locking position (1)- figure (4.7).
• Raise the ramps with the aid of the
tractor's hydraulic system.
Move the levers of the hydraulic
distributor (2) to position "1"-
rising the ramps.
• Check that the spring catch pins
properly lock the ramp in the raised
position.
• Unlock and remove the pin (1) locking
the support foot (4) - figure (4.6).
• Slide the foot in (4) and lock it with
the pin (1) - figure (4.6).
• Unlock and remove the pin (2).
• Fold the support (3) to transport po-
sition and lock it with the pin (2).
ATTENTION
After finishing ramps folding, make sure that spring
catches are in ramp locking position.
After folding, the ramps must be secured with safety
straps. Do NOT drive when the ramps are not se-
cured.
Safety straps must be properly tensioned to mini-
mize the ramp movements during travel.
Before moving off, check that the ramps are raised
and properly secured.
Correct use
H.3.1.621.06.1.EN