PRONAR RC3100 Operator's Manual page 65

Correct use
• Unlock cotter pin of pin (4), remove
safety pin (3).
• Turn support foot to position (2).
• Insert the pin in position (B) and
secure it with cotter pin (4).
• Prior to moving off, release trailer's
parking brake.
ATTENTION
Do NOT move off or drive with the support raised
only by means of the hydraulic cylinder. The support
must be set to driving position.
Do NOT travel with the trailer if the support securing
elements are damaged or lost – safety pin (3) and
R-clip (4).
SETTING THE SUPPORT TO PARKING
• Immobilise tractor and trailer with
parking brake.
• Unlock the cotter pin (4) and remove
the safety pin from position (B) –
figure (4.5).
Be especially careful when operating the support –
this refers also to bystanders or helpers.
While turning the support, be especially careful and
do not place hands between the support mounting
socket and the support. Danger of severing or crush-
ing.
• Turn the support to position (1).
• Insert the pin in position (A) and
• Set the cut off valve (5) to the open
• Operate the hydraulic distributor
• Drawbar hitching eye should be
POSITION
• Lock the support by moving the valve
DANGER
secure it with cotter pin (4).
position "O" - decal (6).
in the tractor in order to lower the
support foot.
slightly raised with regard to the
tractor hitch in order to facilitate un-
hitching the trailer.
lever (5) to the closed position "Z" –
decal (6).
PRONAR RC3100
Section 4
H.3.1.621.04.1.EN
4.9