Correct use
ATTENTION
Before loading and unloading, lower the ramps until
they fully rest on the ground. Lowered ramps should
be at the same height. Rear supports must be un-
folded.
To install the extensions - figure (4.11):
• set the extension brackets (1) to the
unfolded position (F),
To release the lock, raise the
latch plate (4).
• pull the bracket (1) out of the profile
(3) until it locks in the unfolded
1
Figure 4.11
Load platform extensions
(1) extension bracket
(4) latch plate
(C) middle plank
(F) bracket in unfolded position
A
2
A
B
C
D
(2) holder for storing extension planks (3) extension profile
(A) external plank
(D) rear plank
DANGER
Overloading the trailer, erroneous loading and secur-
ing of the load is the most frequent cause of acci-
dents during transport.
Uneven arrangement of the load may cause over-
loading of the trailer's axle.
People or animals must not be carried on the trailer.
position (F),
• install the extension planks according
to figure 4.11.
Wheels, brackets, supports or other load
elements, item (1), figure (4.10), which
carry the machine load, must be arranged
C
2 3 0 5
m m
2 0 2 5
m m
1 9 7 5
m m
1 5 6 0
m m
PRONAR RC3100
Section 4
B
A
D
3
1
E
4
3
1
F
4
209-H.11-1
(B) ramp plank
(E) bracket in folded position
4.19