Table of Contents
Advertisement
Correct use
• Unlock and remove the pin (1).
To facilitate the removal of the
pin, raise the foot until the pin
rotates easily.
• Slide out the support foot (4) to the de-
sired height and secure it by locking
with a pin (1).
DANGER
When unfolding and folding the rear supports of the
trailer, be especially careful because there is a risk
of crushing fingers.
• Unfold the other rear support in the
same way.
• Loosen and remove the safety straps
(6) - figure (4.6).
• Release the ramp's spring catch
mechanism.
Pull the lever back to position
(2) - figure (4.7). In this position,
the catch lever cannot be auto-
matically closed.
• Lower the ramp to the working
position.
• Repeat the procedure for the second
ramp.
1
Figure 4.7
Spring catch
(1) latch lever in locking position
(2) latch lever in releasing position
RISING THE RAMPS
• Move the spring catch to the ramp
locking position (1)- figure (4.7).
• Manually raise the ramp to the folded
(transport) position.
• Check that the spring catch pins
properly lock the ramp in the raised
position.
ATTENTION
After finishing ramps folding, make sure that spring
catches are in ramp locking position.
After folding, the ramps must be secured with safety
straps. Do NOT drive when the ramps are not se-
cured.
Safety straps must be properly tensioned to mini-
mize the ramp movements during travel.
Before moving off, check that the ramps are raised
and properly secured.
PRONAR RC3100
Section 4
2
621-H.07-1
4.11
Advertisement
Table of Contents
