Loading And Unloading - PRONAR T680 Operator's Manual

SECTION 2
• After changing the hydraulic oil, the used oil should be properly disposed of. Used
oil or oil which has lost its properties should be stored in original containers or
replacement containers resistant to action of hydrocarbons. Replacement
containers must be clearly marked and appropriately stored.
• Do not store hydraulic oil in packaging designed for storing food or foodstuffs.
• Rubber hydraulic conduits must be replaced every 4 years regardless of their
technical condition.

2.1.5 LOADING AND UNLOADING

• Loading and unloading work should be carried out by persons experienced in this
type of work.
• Before loading make certain that linking cables are installed. Otherwise, load
exerting pressure on the walls will cause damage to the walls. If the loaded
material does not exert any pressure on the trailer side walls, it is permitted to
dismantle clamping cables.
• Use only original tipping pins with a handle. Using non-original pins could damage
the trailer. When tipping the load box and travelling, the pins must be located in
the load box sockets and must always be secured with cotter pins.
• The trailer is not intended for transporting people, animals or hazardous
materials.
• The load must be arranged in such a way that it does not threaten the stability of
the trailer and does not hinder driving.
• The arrangement of the load may not cause an overload on the axle of the trailer.
• Incorrect load distribution and overloading the machine may cause the trailer to
tip over or cause damage to its components.
• Do NOT climb on load box during loading and unloading.
• Unloading and loading of trailer may only take place when the machine is
positioned on level and hard surface and connected to tractor. Tractor and trailer
must be placed to drive forwards.
2.5
Pronar T680