PRONAR RC3100 Operator's Manual page 72

Section 4
DANGER
Avoid accidental turning off the winch by disconnect-
ing it mechanically from the power supply. When the
winch is not in use, set the gear lever to the "OUT" or
"IDLE" position.
The winch motor must not be
started in the "IDLE" position.
• Extend the winch rope along the load
platform and fasten the load with the
hook (5).
• Switch the lever (3) to the "WORK"
position - to do this turn the lever by
90 .
O
Do not start the engine until the
gear meshes. In order to mesh
the gear pull the rope.
TIP
The winch can also be operated using a wireless re-
mote control.
4.16 PRONAR RC3100
ATTENTION
The machines pulled onto the trailer must have axles
and wheels.
Do NOT move the tractor and trailer if the winch rope
is extended and attached to the load located outside
the trailer.
Do NOT use additional accessories to extend the
winch rope.
Do NOT unwind the rope to its full length. At least 5
rope fakes must remain on the drum.
Do not exceed the maximum winch pulling force. The
maximum winch pulling force and the winch pulling
force depending on the number of rope layers wound
on the drum is shown in the warning decal (6). The
decal is located on the trailer's front wall.
• Pre-tension the winch rope using the
remote control (4).
• Check the hook fixing (5).
• Pull the load onto the trailer platform.
The winch is not equipped with
locking mechanism. The load
pulled onto the trailer platform
should be properly secured.
Correct use
H.3.1.621.07.1.EN