Setting Up The Chassis - Cisco AS5300 Manual

• RJ-45-to-DB-9 female DTE adapter (labeled TERMINAL)
• RJ-45-to-DB-25 female DTE adapter (labeled TERMINAL)
• RJ-45-to-DB-25 male DCE adapter (labeled MODEM)
• RJ-45-to-RJ-45 rollover console cable
• ESD-preventive wrist strap
• Nylon cable tie
• Cable tie holder
• Grounding lug
You might need the following equipment, which is not included:
• Four screws for installing the access server in a rack
• Straight-through RJ-45-to-RJ-45 cable for an Ethernet connection
• Ethernet hub or PC with a network interface card for Ethernet LAN connections
• Up to four straight-through RJ-45-to-RJ-45 cables for T1 connections
• Up to four E1 cables for E1 connections
• PC running terminal emulation software for local administrative access
• Modem for remote administrative access

Setting Up the Chassis

You can set the chassis on a desktop or install it in a rack. Use the procedure in this section that
best meets the needs of your network:
• Setting the Chassis on a Desktop
• Rack-Mounting the Chassis
Warning