Using The Dual Power Meter Display - Agilent Technologies X Series User Manual

Optimizing Performance

Using the Dual Power Meter Display

Using the Dual Power Meter Display

The dual power meter display can be used to display the current frequency and power of either one
or two power sensors. The display outputs the current frequency and power measured by the power
sensors in the larger center display and in the upper right corner of the display. Refer to
Figure 5- 2, and Figure 5-
Figure 5-1 Dual Power Meter Display with Power Sensors A and B Calibrated
For details on each key, use key help as described on
86
3.
page 44.
Once turned on, the
power meter
readings are always
visible, even if
another instrument
feature is selected
(i.e. Sweep, AM,
etc.).
This area is the main
display for the dual
power meter
calibration frequency
and current power
measured.
If channel A or
channel B power
sensors or both are
displayed, and the
AMPTD or the FREQ
softkeys are pressed,
the large power
meter measurements
remains displayed.
After the first
connection, if the
connection is
successful, the
model number and
serial number of the
power sensor is
displayed.
Agilent X-Series Signal Generators User's Guide
Figure 5- 2,