Selecting The Input Direction; Choosing The Logic Type And Port Configuration - Agilent Technologies X Series User Manual

Digital Signal Interface Module (Option 003/004)
Operating the N5102A Module in Input Mode

Selecting the Input Direction

If both Option 003 (output mode) and Option 004 (input mode) are installed, you must select the
input direction.
Press Data Setup > Direction Input Output to Input and press Return.
NOTE If only Option 004 is installed, the direction softkey will be unavailable and the mode
will always be input.

Choosing the Logic Type and Port Configuration

Figure 10-18Logic and Port Configuration Softkey Menus
1. Refer to Figure 10-
From this menu, choose a logic type.
CAUTION Changing the logic type can increase or decrease the signal voltage level. To avoid
damaging the device and/or the N5102A module, ensure that both are capable of
handling the voltage change.
282
18. Press the Logic Type softkey.
Agilent X-Series Signal Generators User's Guide