Operating The N5102A Module In Output Mode; Setting Up The Signal Generator Baseband Data; Accessing The N5102A Module User Interface - Agilent Technologies X Series User Manual

Operating the N5102A Module in Output Mode

This section shows how to set the parameters for the N5102A module using the signal generator UI
in the output direction. Each procedure contains a figure that shows the softkey menu structure for
the interface module function being performed.

Setting up the Signal Generator Baseband Data

The digital signal interface module receives data from a baseband source and outputs a digital IQ or
digital IF signal relative to the selected logic type. Because a signal generator provides the baseband
data, the first procedure in operating the interface module is configuring the signal generator using
one of the real- time or ARB modulation formats, or playing back a stored file using the Dual ARB
player. For information on configuring the signal generator, refer to
Operation (Option 653/655/656/657)," on page
1. Preset the signal generator.
2. Select the modulation format (GSM, Custom, and so forth) and set the desired parameters.
3. Turn- on the modulation format.

Accessing the N5102A Module User Interface

shows the Auxiliary menu that is accessed by pressing the Aux Fctn key on the front
Figure 10- 9
panel of the signal generator.
Figure 10-9 First-Level Softkey Menu
Aux Fctn
Agilent X-Series Signal Generators User's Guide
Digital Signal Interface Module (Option 003/004)
Operating the N5102A Module in Output Mode
145.
Chapter 8, "Basic Digital
Select either PXB or N5102A
connectivity.
The default selection is N5102A.
Press here to access the N5102A
menu.
269