Alpha Group OutBack Power FLEXmax Series Owner's Manual page 47

Misc Screen #1
GT STATE PWM%
255 07 50.0
EXIT NEXT
Misc Screen #1
GT STATE PWM%
255 07 50.0
EXIT NEXT
Force Bulk/Float Screen
EXIT NEXT FLOAT
PCB Target BTMP CFB
512 14.4v
EXIT BACK
PCB Target
512 14.4v
EXIT BACK
PCB Target
512 14.4v
EXIT BACK
PCB Target BTMP
512 14.4v
EXIT BACK
C
900-0009-01-00 Rev
To bring the charge controller out of Snoozing mode:
ChgT
005
1. Press <RSTRT>.
RSTRT
2. Press <EXIT> to return to the main menu.
To force the charger into a Bulk or Float charge cycle:
ChgT
005
1. Press <NEXT>.
RSTRT
2. Select either a Float or Bulk charge cycle. Forcing a Float or
Bulk recharge will end an EQ cycle. See page 20 for details on
these modes.
FORCE

BULK

3. Press <EXIT> to return to the main menu, or
press <NEXT> to view the next miscellaneous screen.
Misc Screen #2
PCB Target BTMP CFB
512 14.4v
EXIT BACK
PCB represents the temperature of the internal components. It
255 0712
is used to control the cooling fan. These values are in digital
counts, not degrees. The lower the number, the higher the
temperature. (25°C is approximately a value of 525.)
The target voltage the controller is trying to reach. This will
BTMP CFB
255 0712
depend on the active stage of the charger and the set target
value for that stage.
BTMP is a battery temperature sensor reference value, used to
BTMP CFB
compensate the charging voltage. The range is 0 to 255. These
255 0712
values are in digital counts, not degrees.
An X next to this value indicates an external RTS is being used in a
system with a HUB and system display.
CFB represents Current FeedBack. This is the output value of the
CFB
255 0712
internal current sensor and is used to calculate output amps and
watts to track the maximum power point of the array.
Figure 34 Miscellaneous Screen #2
Press <FLOAT> to force a Float charge.
Press <BULK> to force a Bulk charge.

Press <BACK> to return to the
255 0712 Force Bulk/Float screen.

Press <EXIT> twice to return to
the main menu.
Operation
45