Table of Contents
Advertisement
5-6 To Install SATA RAID Driver
SATA-RAID Driver is incorporated in Support CD/Floppy Disk for user's
installation. The Driver Floppy Disk is needed for SATA RAID installa-
tion on Windows 2K/XP. If you cannot find this Driver Floppy Disk in the
mainboard package, you can make one by copying the driver from the
Driver CD into a Floppy Disk.
5-6-1 To Install SATA RAID Driver on Windows 2000/XP
(1) Get ready the Floppy Diskette holding the RAID Driver.
(2) Check that SATA Hard Disks are connected properly to the SATA
Connectors.
(3) Start your PC system and use RAID BIOS Setup Utility to configure
RAID 0 or RAID 1 to the hard disks. (For SATA Interface, skip the
RAID configuration.)
(4) Restart System and format the bootable hard disks.
(5) Now, apply the Windows 2000/XP CD to CD-ROM for operating
system installation.
(6) On the Windows 2000 Setup screen, press "F6" key to set up RAID
driver for Windows 2000/XP.
Windows Setup
Press F6 if you need to install a third party SCSI or RAID driver....
(7) On next screen when you are instructed to insert the RAID Driver
Diskette into Floppy drive, follow the instruction to continue and
complete the installation.
Chapter 5 VIA VT8237R SATA RAID
85
Advertisement
Table of Contents
