Installing Slide-Mounted Accessories
Thermo Scientific
Slide any Foundation Series Swap-Top Module into the holder, rotate the accessory to line up
the notches and pins and then hand tighten the screws (see the image above). For diffuse
reflection accessories, remove the two screws and lower panel to accommodate the sample
slide as shown in the image below.
Related Topics
•
Installing an Accessory
The iD1 Transmission Accessory is designed to accommodate gas or liquid transmission cells
and thin film or pellet holders that have a 2 x 3 inch slide mount.
Installing an Accessory
Nicolet iS5N Spectrometer User Guide
2
Operation
13