Advertisement
Connecting an Integrated Amplifier (ZONE 2)
a
a Analog audio cable
You can enjoy 2 ch audio in the separate room (ZONE 2) while performing
playback in the main room (where this unit is located). Use an analog audio
cable to connect the ZONE 2 PRE/LINE OUT jack on this unit to the input jack
on an integrated amplifier in the separate room.
PRE OUT
Setup
Input
Terminal
Integrated
amplifier
‰ Multi-zone ( →p108)
‰ Playing Back (ZONE 2) ( →p109)
• If the AV component is not equipped with an HDMI jack, use a digital coaxial
cable, digital optical cable or analog audio cable. Also, the audio from
externally connected AV components can be output to ZONE 2 only when the
audio is analog or 2 ch PCM signal. When the AV component is connected to
this unit with a digital coaxial cable or digital optical cable, change the audio
output of the AV component to the PCM output.
• Settings are required to output audio to ZONE 2. Press
controller to display the Home screen, then set "System Setup" - "Speaker" -
"Configuration" - "Zone 2 Preout" ( →p136) to "Zone 2".
• When connecting an integrated amplifier that does not have a volume control,
in the System Setup, set "Multi Zone" - "Zone 2" - "Output Level" ( →p152)
to "Variable (Default Value : Fixed)". If you do not set this, the volume output
will be very loud and there is a danger of damage to the integrated amplifier,
speakers, etc. When connecting an integrated amplifier that has a volume
control, leave this as "Fixed".
Connections
on the remote
72
Advertisement
