Advertisement
General Specifications
Amplifier Section
Rated Output Power
Maximum Effective Output Power
THD+N (Total Harmonic Distortion + Noise)
Input Sensitivity and Impedance
Rated RCA Output Level and Impedance
Rated XLR Output Level and Impedance
Phono Maximum Input Signal Voltage
Frequency Response
Tone Control Characteristics
Signal to Noise Ratio
Supported impedance of Speakers
Headphone Rated Output
North American and Taiwanese models
(North American models)
With 8 ohm loads, both channels driven, from 20Hz-
20kHz; rated 150 watts per channel minimum RMS
power, with no more than 0.08% total harmonic
distortion from 250 milliwatts to rated output. (FTC)
(Taiwanese models)
11 ch × 220 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD
(IEC)
(North American models)
260 W at 6 ohms, 1kHz, 1 ch driven of 10%THD
0.08% (20 Hz - 20,000 Hz, Rated output power)
200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM), ±0.2 mV/44 kΩ (LINE(XLR))
LINE OUT (ZONE 2, ZONE B): 200 mV/2.2 kΩ
10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Direct)
MAIN : ±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE)
ZONE 2 : ±10 dB, 100 Hz (BASS), ±10 dB, 10 kHz (TREBLE)
ZONE 3 : ±10 dB, 100 Hz (BASS), ±10 dB, 10 kHz (TREBLE)
107 dB (IHF-A, LINE IN, SP OUT), 78 dB (IHF-A, PHONO IN, SP OUT)
European, Australian and Asian models
11 ch × 220 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD
(IEC)
11ch × 260 W at 6 ohms, 1 kHz, 1 ch driven of 10%
THD (JEITA)
PRE OUT : 1 V/470 Ω
PRE OUT (ZONE 2) : 1 V/ 2.2 kΩ
LINE OUT (ZONE 3) : 200 mV/470 Ω
PRE OUT : 2 V/220 Ω
70 mV (MM 1 kHz 0.5%)
4 Ω - 16 Ω
75 mW + 75 mW (32 Ω, 1 kHz, 10% THD)
Appendix
214
Advertisement
