Advertisement
Rear Panel
I J
K
I AUDIO IN jacks: Input AV component audio
signals with an XLR balanced cable or analog
audio cable.
J SIGNAL GND terminal: Connect the ground
wire of the turntable.
K COMPONENT VIDEO IN jacks: Input AV
component video signals with a component
video cable. (Compatible only with 480i or 576i
resolution.)
VIDEO IN jacks: Input AV component video
L
M
N
PRE OUT
P
Q
signals with an analog video cable.
L ZONE 2 PRE/LINE OUT jacks: Output audio
signals with an analog audio cable connected
to an integrated amplifier in a separate room
(ZONE 2).
ZONE B LINE OUT jacks: Simultaneously
output the same audio source as the speakers
(ZONE A) connected to this unit by connecting
this unit to wireless headphones, wireless
speaker transmitter, etc., using an analog audio
cable.
M ZONE 3 PRE/LINE OUT jacks: Output audio
signals with an analog audio cable connected
O
to an integrated amplifier in a separate room
(ZONE 3).
N SUBWOOFER PRE OUT jacks: Connect a
powered subwoofer with a subwoofer cable. See
"Connect the Subwoofer" ( →p41) for details.
O PREOUT jacks: Connect a power amplifier.
( →p61)
P SPEAKERS terminals: Connect speakers with
speaker cables. (Support banana plugs. Use a
plug 4 mm in diameter. Y plug connection is not
supported.)
Q IR IN/OUT port: Connect a remote control
receiver unit. ( →p76)
R 12V TRIGGER OUT A/B jack: Connect a device
equipped with a 12V trigger input jack to enable
power link operation between the device and this
unit. ( →p77)
S RS-232C port: Connect a home control system
equipped with an RS-232C port. For installing
a home control system, contact the specialized
stores.
RS
17
Advertisement
