Advertisement
Speaker
Center, Height 1, Height 2, Surround:
When the "Setting Type" is "Common" ( →p137)
Set according to the speakers to be used.
"Small": When speaker where the speaker diameter is 16 cm or less are to be
used.
"Large": When speaker where the speaker diameter is larger than 16 cm are to
be used.
• When "Front" is set to "Small", this is set to "Small".
• If an item cannot be selected even though connection is correct, check that
the settings in "Configuration" - "Speaker Channels" matches the number of
connected channels.
When the "Setting Type" is "Individual" ( →p137)
Set how many Hz for the range of each channel, with crossover frequencies
selectable between "40 Hz" and "200 Hz".
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is set to "Full Band".
• If an item cannot be selected even though connection is correct, check that
the settings in "Configuration" - "Speaker Channels" matches the number of
connected channels.
Surround Back:
When the "Setting Type" is "Common" ( →p137)
Set according to the speakers to be used.
"Small": When speaker where the speaker diameter is 16 cm or less are to be
used.
"Large": When speaker where the speaker diameter is larger than 16 cm are to
be used.
• When "Surround" is set to "Small", this is set to "Small".
• If an item cannot be selected even though connection is correct, check that
the settings in "Configuration" - "Speaker Channels" matches the number of
connected channels.
When the "Setting Type" is "Individual" ( →p137)
Set how many Hz for the range of each channel, with crossover frequencies
selectable between "40 Hz" and "200 Hz".
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Surround" is set to "Full Band".
• If an item cannot be selected even though connection is correct, check that
the settings in "Configuration" - "Speaker Channels" matches the number of
connected channels.
Crossover(*):
When there are speakers that have been set to "Small", set the Hz under which
you would like other speakers to play bass, and also set Hz under which you
would like the LFE (low frequency effect) to play the bass.
The value from "50 Hz" to "200 Hz" can be set.
* Can be selected when the "Setting Type" is "Common". ( →p137)
LPF of LFE(*):
Set the low-pass filter for LFE (low-frequency effect) signals in order to pass
only the lower frequency signals than the set value, and thus cancel unwanted
noises. The low-pass filter is effective only on sources with LFE channel.
The value from "80 Hz" to "120 Hz" can be set.
"Off": When this function is to not be used
* Can be selected when the "Setting Type" is "Individual". ( →p137)
Setup
138
Advertisement
